Surface Preparation: Before starting to grout, remove debris in grout joints and lightly sponge the tile surface to remove dust and dirt. Do not clean tiles with acid cleaners. In case acid cleaners were used to clean the tiles, ensure to wash the area with plenty of water before commencing grouting. Substrate temperature must between 65°F (18°C) and 90°F (32°C). Mixing Open the container and mix with margin trowel or spatula using HANDS ONLY to get homogeneous consistency. Use of drill mixer is strictly not recommended as it will inhibit excessive air bubbles into the product and cause pin holes in joints & grout sagging on vertical applications. DO NOT MIX WATER, SOLVENTS, LATEX, or any other liquids for workability. Cleaning Remove excess grout from the face of the tiles with the edge of the grout float. Hold the float at a 90° angle and pull it diagonally across the joints and tile to avoid pulling out the material. Initial Cleaning:

Final Cleaning: If clear halos, residue remains on the surface after 16-24 hrs, clean the surface with clean water /soap water using the other side of Scrubber (White nylon side). Use the scrubber given with the grout kit and run the scrubber in circular motion to remove the dried haze, residual grout material, by applying pressure depending on the haze thickness and concentration, from tiles. Occasionally clean the scrubber in potable water, squeeze all the water, and keep working till the grout haze is removed. Allow the grout to cure for at least 3 days to permit heavy foot traffic.  Protect grout from stains and chemicals during the cure process.