FAQs

Not true. In fact it is easier with two component products as there is no water mixed at site. The performance of single powder product depends on the quality of water mixed in it. Many times the water quality is bad on building sites and contaminants in it affect the performance of single powder adhesives.
You can use cement based grout (LATICRETE® 500 series sanded grout / LATICRETE® 600 series un-sanded grout) mixed with LATICRETE® 1776 grout admix plus for filling these spaces. You can also use STELLAR™ Grout or SP-100™ DUO.
No. It is mandatory to have spacing between the tiles when installed on external façade or floors. The thermal movements are very high and spacers are must to accommodate such movements.
No, do not use cement based adhesives for installation of engineered stones, agglomerates & Quartz. We recommend using PUA 212® for such installations.
There is no height restriction when you want to install tiles using LATICRETE® 335 Super Flex.
Yes, you can install natural stones with LATICRETE® 335 Super Flex. However, we recommend using LATICRETE® 320 & LATICRETE® 340 basis the area of application.
Yes. For external tile installations, the thermal stresses are critical and would need adhesive to become accommodative to the movements arising from these stresses. LATICRETE® 335 Super Flex has the ability to accommodate such movements.
The maximum size of tile is 1200 mm X 1200 mm for installation with LATICRETE® 335 Super Flex. If you are installing tiles larger than this size we recommend using LATICRETE® 345 Super Flex.
For 20 Kg bag of LATICRETE® 335, one needs 5 to 6 Litres of water. Mix water depending upon the consistency of mix required and ambient environmental conditions.
LATICRETE® 335 Super Flex is high polymers and cement based thin set adhesive which is mixed with water and used for tile / stone installation in internal and external areas.
This site is registered on wpml.org as a development site. Switch to a production site key to remove this banner.
Enquire Now